Johnson-systems DMX 6-PORT MERGER Manual de usuario descargar pdf (Pagina 13)

WWW.JOHNSONSYSTEMS.COM 13

+12VDC Power Supply Output Connector

(1) DMX Output Connector

EEPROM Memory Module

(6) DMX Input Connectors

+12VDC Power Supply Input Connector

USB Tech Port

DMX-6PM Controller Board

The DMX-6PM controller board is the central electronic control system (aka brain) for all

DMX 6-PORT MERGER models.

+12VDC Power Supply Output for Models: DMX-6PIM, DMX-6PIM-FM

The AC-DC power supply located at the top of the enclosure is capable sourcing up to a total of

30 Watts (2.4 Amps) of power at 12VDC. Up to 24 Watts (2 Amps) may be used to power external

devices via the provided 6-pin breakaway type connector. Two (2) 1.109" knockouts (suitable for

0.75" conduit) are located on the bottom of the enclosure, and are the recommended locations

for the DC wire (conduit) entry. Unplug the breakaway connector to terminate the wires. Use a

1/8" athead screwdriver to torque the connector terminals to the specication provided below.

Once the wire termination is complete, plug the breakaway connector back in and ensure it is fully

seated. Verify all wiring terminations and secure the lid before powering up.

Breakaway Type Connector Wire Termination

• Terminate to +12VDC and COMMON on the J9 connector.

• Use wire size #28 to #12 AWG copper wire only, rated for 167°F (75°C) minimum.

• Strip insulation length to 0.3" (7.5mm).

• Torque connector terminals to 3.6 IN-LBS (0.4 NM).

NOTE: Ensure external devices do not exceed the maximum combined current draw of 2 Amps.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

Sin comentarios

Johnson-systems DMX 6-PORT MERGER Manual de usuario Pagina 13