Johnson-systems DMX 6-PORT MERGER Manual de usuario descargar pdf (Pagina 11)

WWW.JOHNSONSYSTEMS.COM 11

Models: DMX-6PM-TB, DMX-6PM-TB-RM

DMX is connected via 3-pin breakaway type connectors, located on the rear panel of the

enclosure. Unplug the breakaway connector to terminate the three (3) wires. Use a 1/8" athead

screwdriver to torque the connector terminals to the specication provided below. Once the wire

termination is complete, plug the breakaway connector back in and ensure it is fully seated.

Breakaway Type Connector Wire Termination

• Strip insulation length to 0.3" (7.5mm).

• Torque connector terminals to 3.6 IN-LBS (0.4 NM).

• Be sure to isolate and protect all shield wires.

3-Pin Breakaway Type Connector Connection Details (Pinout)

• Pin 1 = (SH) DMX Shield / Common

• Pin 2 = (D-) DMX Data-

• Pin 3 = (D+) DMX Data+

Models: DMX-6PM-XLR, DMX-6PM-XLR-RM

DMX is connected via 5-pin XLR type connectors, located on the rear panel of the enclosure.

There are six (6) male connectors for the DMX inputs and one (1) female connector for the DMX

output. Before connecting, ensure the DMX cable complies with industry standards.

5-Pin XLR Connection Details (Pinout)

Pin 1 = DMX Shield / Common

Pin 2 = DMX Data-

Pin 3 = DMX Data+

Pin 4 = Not Used / No Connection

Pin 5 = Not Used / No Connection

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Sin comentarios

Johnson-systems DMX 6-PORT MERGER Manual de usuario Pagina 11